Front Panel Facilities - Pioneer SX-303R Operating Instructions Manual

FRONT PANEL FACILITIES
• The illustration shows SX-303R.
E3O_E31lr_nt_'a _ ÷ _ . L
U POWER (STANDBY/ON) switch/STANDBY
indicator(SX-303R, SX-253R)
This is the switch for electric power.
ON: When set to the ON position, power is supplied and
the unit becomes operational.
STANDBY: When set to the STANDBY position, the main pow-
er flow is cut and the unit is no longer fully opera-
tional. A minute flow of power feeds the unit to
maintain opetation readiness.
The STANDBY indicator is illuminated during stan-
dby mode.
• The accessory remote control unit can also be used to operate
STANDBY/ON.
(_ S.BASS button (Super BASS)
When this button is pressed, the bass sound will be emphasized.
(_) RETURN button
This is helpful during troubleshooting or when no sound is output.
Pressing this button returns the receiver to the following settings,
the sound level being controlled by VOLUME control.
• TAPE 2 MONITOROFF
• FUNCTION TUNER
• BAND FM/AM*
* The last FM/AM broadcast you were listening to will be
received. When reception is not possible, search begins for fre-
quency that can be received.
NOTE:
When the power is initially turned ON, muting will be applied to
prevent sound from being output for approx. 5 seconds.
i_ POWER switch/POWER indicator (SX-203)
When this switch is pressed, power is supplied to the unit and the
indicator lights up.
Press the switch again to turn power OFF.
[Timer ON/OFF possible]
When the unit is switched ON, ON/OFF control can be performed
by means of the optional timer.
NOTE:
When the power is initially turned ON, muting will be applied to
prevent sound from being output for approx 5 seconds.
TAPE 2 MONITOR button
Press when listening to tape playback with the cassette deck 2.
Function buttons
Use to select playback source.
[TAPE 1/VCR] - Press when listening to tape playback
with the cassette deck 1 or video cassette recorder.
[PHONO] - Press when listening to record playback on
a turntable.
[TUNER] - Press when listening to AM or FM broadcasts
with a tuner.
[LD] - Press when listening to programs from a compo-
nent connected to the LD jacks.
[CD]- Press when listening to compact disc playback
with a CD player.
6
<ARB1470>
NOTE:
If no sound is output after the RETURN button is pressed, make
sure that SPEAKERS switches are turned on.
DIRECT ACCESS tuning button
When this button is pressed, the STATION CALL buttons func-
tion as ten-key number buttons for direct input of the desired
reception frequency. Press again to cancel this mode.
If the input station fall outside of the receiver's tuning range, the
display section will display a message: "UPPER" if the frequency
is too high and '_LOWER" if it is too low (see page 10).
(_ FM/AM selector button
This button is used to select either AM or FM reception.
MEMORY SCAN button
This button is used for station memory scan.