Table of Contents
Advertisement
Cable TV Setup
This setup applies only when you have cable television.
To select
between
a regular TV antenna
and a cable input:
1.
Press MENU on the remote control to display the VCR's
main MENU.
MENU
PROGRAR
SET
UP
.
SELECT=(A•
ENTER)
END=(HENU)
Use the • • arrow keys to highlight
the PRESET selection,
and press ENTER on the remote control.
PRESET
CLOCK
SET
=_
SELECT=(A•)
END=(MENU)
,
Use the • • arrow keys to highlight
the CH MEMORY
selection, and press ENTER on the remote control.
EH RERORY
m]
IEAT
E
AUTO
SCAN
ON
ADO
CH
--CH
ERASE
EH
--CH
SELECT=(&•"
")
END=(RENU)
4,
Use the < m,arrow buttons
on the remote to highlight
the
CATV selection,
then press MENU on the remote control.
Your VCR is now set up to accept a cable signal. You will
tune to the channel that your TV uses to see the signal. If
recording
cable TV programming,
you need to make sure
the VCR is set to this same channel
(usually 03, 04, or the
Video Input Channel).
Video Input Channel?
If you use your Audio/Video
jacks to
connect your VCR to your TV, then
you need to tune to the TV's video
input channel to see the picture.
For more information
on the superior
quality of a video input channel
picture, see How to Find Your TV'S
Video Input Channel in the Reference
section of this manual or your TV's
User's Guide,
9
Advertisement
Table of Contents
