Table of Contents
Advertisement
Connecting
Your TV
4. Drill holes in cabinet
• Drill l/4-inch diameter holes through the underside of the cabinet bottom using the
five circles on the mounting guide as a guide.
5. Remove mounting guide and drill shavings
Remove the mounting guide and clean the drill shavings from inside and under the
cabinet.
6. Select spacers if required
• The spacers slip over the ends of the screws and allow you to mount the TV below
the edge of the cabinet's overhang.
• If your cabinet does not have an overhang, you probably will not need to use any
spacers.
• If your cabinet has an overhang, select the proper length spacer(s) so the TV will
clear the overhang when swiveled.
• Two or three spacers can be used together to make lengths of 1/4" to 1-3/4" at 1/4"
increments. Refer to the chart below to select the proper spacers:
7. Select proper length of screws
• Only five screws are ne_ied. The size you need depends upon your type of cabinet.
• Holding the selected spacers for one of the screw holes under the cabinet, install a
washer and screw inside the cabinet using one of the three lengths of screws
provided.
Note: A visual description of these parts is on page 2.
8. Position mounth_g bracket under cabinet
• Position the mounting bracket under the cabinet as shown and match the screw
holes.
9. Attach mounting
bracket
to cabinet
• First mount one comer of the bracket.
Hold the bracket and spacer(s) in place and
insert the screw from
the inside of the cabinet
down through washer and drilled
hole or down through countersink
and drilled hole.
Note: The washers must be used on metal cabinets and on wood cabinets if you do not
countersink the drilled holes.
* Position the washer flat-side down and
place
screw into screw
bole, through
the
spacer(s)
and through the screw hole in the mounting
bracket.
• Place a nut into the cylinder
at the bottom of the mounting
bracket
screw hole.
Hold nut in place (if necessary, use the top of a pencil).
While maintaining
upward
pressure
on the mounting
bracket,
finger tighten the screw.
Do not tighten firmly
until all five screws have been started.
• Align each of the remaining
mounting bracket
screw holes with the drilled holes
and properly
position the selected
spacers.
Install washers, screws, and nuts as
previously
described.
Now, finish tightening
the five screws but do not overtighten
them.
Less t han I "
1"to 1-1/4"
1-1/4" to 1/2"
1-1/2" to 1-3/4"
1-3/4" to 2"
1/4" Spacers
I/2" Spacers
3/4" Spacers
I" Spacers
3/4"
Spacer
1/4"to3/4"for
ProperMounting
17
Advertisement
Table of Contents
