GE 09GP110 Manual page 20

Connecting Your TV
10. (Optional)Attach Supplied Antenna to Bottom of TV
If you have attached the supplied dipole antenna to the top of your TV, you will need
to attach it to the bottom of your TV before mounting it. If you have connected
another type of antenna, skip to step I 1
If the dipole antenna is attached to the top of the TV, you can remove it by
grasping the base and lifting it up and off.
Insert the antenna base into the pocketed slot on the bottom of your TV. Press
the base of the antenna into the slot until it locks in place.
Connect the ends of the twin-lead to the antenna adapter (supplied).
Connect the antenna adapter to the round antenna connector on the back of the
TV.
Later, after you have turned on the TV, adjust the length and position of the
antenna for best reception.
• For viewing VHF channels 2-13, extend the rods fully.
• For viewing UHF channels 14-69, shorten the rods for best reception.
• For listening to the radio, ff necessary, adjust the antenna rods for best
reception.
®
11. SHde TV onto Bracket
• Slide the TV onto the mounting hook of the bracket and push it all the way back
until the hook on the bracket locks into the back of the TV.
• Secure the TV in the bracket by sliding the locking tab on the back of the bracket
into the bracket assembly. You should hear a click sound when the sliding tab is
locked into position.
Warning: make sure the locking slide is pushed fully into the locked position.
Failure to lock the sliding tab into position may allow the TV to fall off the bracket
causing personal injury or damage to the TV. Push the sliding tab into the bracket
Iassembly until you hear a click.
• To remove the TV, slide the locking tab out of the bracket assembly.
• Lift the TV up and gently pull forward.
Note: The TV must be slightly below the cabinet overhang when installed in the bracket.
Some clearance is necessary so the TV can be easily rotated to the desired viewing angle or
removed for portable use.
12. Attach AC Power Cord
• First attach the AC power cord to the 4-prong conn_tor on the back of the TV.
• Then extend the cord and plug it into an electrical outlet.
13. Attach Cord Hooks
• You can use the cord hooks to hold the cord out of the way.
• For the most attractive appearance, place the cord hooks at the back edge of the
cabinet (on or next to the wall) directly above the outlet to be used.
• To attach the cord hooks, peel off the adhesive back and attach the hooks to a
clean, dry surface on underside of cabinet or back wall.
• Use the cord tie that is attachedto the power cord to wrap and tie excess cord out
, of sight.
18