Maytag MGD7000AW0 Use & Care Manual page 11

5. Adjust cycle settings, if desired
10-cycle model shown
You may adjust different settings, depending on whether you have
selected a Sensor Cycle, Timed Cycle, or Steam Cycle. See the
"Cycle Guide" for detailed information.
NOTE: Not all options and settings are available with all cycles.
Not all cycles are on all models.
Sensor Cycles:
You can select a different dryness level, depending on your load,
by touching DRYNESS LEVEL to scroll to More, Normal, or Less.
Selecting More, Normal, or Less automatically adjusts the dryness
level at which the dryer will shut off. Once a dryness level is set, it
cannot be changed without stopping the cycle.
Sensor cycles give the best drying in the shortest time. Drying time
varies based on fabric type, load size, and dryness setting.
Timed Cycles:
When you select a Timed
Cycle, the default time appears
in the display. Touch + and - to
increase or decrease the time
in 1 -minute increments. Touch and hold to change the time in
5-minute increments.
The default temperature may be changed by touching Temperature
until the desired dry temperature is lit.
Steam Cycles:
Refresh with Steam:
Reduces light wrinkles from loads left in the dryer too long.
Do not add dryer sheets. The cycle time defaults to 15 minutes.
Custom Refresh with Steam:
Smooths out wrinkles and reduces odors from loads consisting of
one to 9 dry items of wrinkle-free cotton, cotton-polyester blend,
common knits, and synthetic garments. Select 1-3, 4-6, or 7-9
garments. The time will adjust with your selection.
6, Select any additional options
Add additional options such as Reduce Static
or Steam Boost by touching that option. If you will
be unable to remove the load promptly, select the
Wrinkle Prevent option before touching START.
NOTE: Not all options and settings are available with all cycles.
f
7, Touch and hold START to begin cycle
hold to start
Touch and hold START to begin the cycle.
8, Remove garments prompUy
after cycle is finished
Promptly remove garments after cycle has completed to reduce
wrinkling. If you will be unable to remove the load promptly, select
the Wrinkle Prevent option.
fChanging- the Sensor Cycle settings
to increase drying time
If all your loads on all Sensor Cycles are consistently not as
dry as you would like, you may change the default settings to
increase the default dryness level.
Your sensor drying settings can be adjusted to adapt to
different installations, environmental conditions, or personal
preference. This change is retained and will affect all of your
Sensor cycles, not just the current cycle/load. There are
5 drying settings, which are displayed using the time display:
01 Factory preset dryness level.
02 Slightly drier clothes, 150/o more drying time.
03 Much drier clothes, 300/o more drying time.
04 Slightly wetter clothes, 150/o less drying time.
05 Much wetter clothes, 300/o less drying time.
To change the drying settings:
NOTE: The settings cannot be changed while the dryer
is running or paused. The dryer must be in standby mode
(power is off) to adjust the default settings.
1. Before starting a cycle, touch and hold DRYNESS LEVEL
for 6 seconds.
2. Touch DRYNESS LEVEL to select the dryness level shown
in the time display: 01,02, 03, 04 or 05.
3. Touch START to save the new dryness level setting.
11