Ice And Water - Maytag MSD2357HES Use & Care Manual

froubleshootln9
ice and Water
No indicator lights
are lit on dispenser
control
Freezer door is not closed.
Verify that freezer door is closed. Power is removed
from the control when freezer door is opened.
Plug in refrigerator.
Replace any blown fuses.
Check circuit breakers for any tripped circuits.
Call local power company listing to report outage.
See Sabbath Mode page 12.
Refrigerator is not plugged in.
Fuse is blown, or circuit breaker needs to
be reset.
Power outage has occurred.
Refrigerator is in Sabbath Mode (select
models).
Ice or water are Freezer door is not closed. Verify that freezer door is closed. Power is removed
not dispensed from the control when freezer door is opened.
when pads are Controls are in lock mode (select models). See Dispenser Lock page 12.
pressed Water tank is filling. At initial use, there is an approximate one- to two-
minute delay in dispensing while the internal water
tank is filling.
Ice maker has just been installed or a Wait 24 hours for ice production to begin or for ice
large amount of ice has been used. maker to restock after emptied.
Water filter is clogged or needs to be Change water filter (see page 13).
changed.
Ice maker is not Ice maker has just been installed or a Wait 24 hours for ice production to begin or for ice
producing enough large amount of ice has been used. maker to restock after emptied.
ice or ice is Water pressure is too low. Low water pressure can cause valve to leak.
malformed Water pressure must be between 35 to 100 pounds
per square inch to function properly. A minimum
pressure of 35 pounds per square inch is
recommended for refrigerators with water filters.
Water filter is clogged or needs to be Change water filter (see page 13).
changed.
Ice maker is not Ice maker arm is up. Confirm ice maker arm is down. See Automatic Ice
producing ice Maker page 15.
Household water supply is not reaching See Connecting the Water Supply pages 4 and 5.
water valve.
Copper tubing has kinks. Turn off water supply and remove kinks.
If kinks cannot be removed, replace tubing.
Water pressure is too low. Water pressure must be between 35 to 100 pounds
per square inch to function properly.
A minimum pressure of 35 pounds per square inch is
recommended for refrigerators with water filters.
Check freezer temperature. See Temperature Controls page 7 to adjust controls.
Freezer must be between 0° to 2° F (-18 ° to -17 ° C)
to produce ice.
Ice bin is not installed properly. See Ice Storage Bin page 9.
Improper water valve was installed. See Connecting the Water Supply pages 4 and 5.
Self-piercing and 3/,j, saddle valves cause low water
pressure and may clog the line over time. The
manufacturer is not responsible for property damage
due to improper installation or water connection.
Water filter Water filter needs to be replaced. If filter is not available, replace with bypass filter.
indicator light is See Water Filter page 13.
red Filter indicator sensor needs to be reset. See Filter Status Indicator Light page 12.
continued..,
26