Maytag MGR5870 User Manual page 24

Maintenance
(continued) oo°°°°oooooo °ooo ooooooooo oooooooooo
Leveling Legs
AUTiON:
legs to the floor This bracket prevents the range
accidentally tipping
The range should be leveled when installed. If the
range is not level, turn the plastic leveling legs,
located at each corner of the range, until
range is level.
ANTI-TIP BRACKET
\LEVELING LEG
Electrical Connection
Appliances which require electrical power are
equipped with a three-prong grounding plug
which must be plugged directly into a prop-
erly grounded three-hole 120 volt electri-
cal outlet.
Proportional Valve Adjustment
for Surface Burners
The LOW setting should pro-
duce a stable flame when
turning the knob from HIGH
to LOW. The flame should
be 1/8 inch or lower and must
be stable on all ports on LOW
setting.
To adjust: Operate burner
on HIGH for about five minutes to preheat burner cap.
Turn knob back to LOW; remove knob, and insert a small
screwdriver into the center of the valve stem. Adjust the
flame size by turning adjustment screw in either direc-
tion, while holding the stem.
Flame must be of sufficient size to be stable on all burner
ports. If flame adjustment is needed, adjust ONLY on the
LOW setting. Never adjust flame size on a higher setting.
NOTE: All gas adjustments should be done by a
qualified servicer only.
Always disconnect power to appliance
bejore servicing.
The three-prong grounding plug offers protection against shock
hazards. DO NOT CUT OR REMOVE THE THIRD
GROUNDING PRONG FROM THE POWER CORD
PLUG.
If an ungrounded, two-hole or other type electrical outlet is
encountered, it is the personal responsibility of the appli-
ance owner to have the outlet replaced with a properly
grounded three-hole electrical outlet.
How to Remove Range
for Cleaning and Servicing
Follow these procedures to remove appliance for clean-
ing or servicing:
1. Shut off gas supply to appliance.
2. Discormect electrical supply to appliance, ifequipped.
3. Disconnect gas supply tubing to appliance.
4. Slide range forward to disengage range from the anti-
tip bracket. (See Installation Instructions for location
of bracket.)
.
Reverse procedure to reinstall. If gas line has been
disconnected, check for gas leaks after reconnection.
NOTE: A qualified servicer should disconnect and
reconnect the gas supply.
6. To prevent range from accidentally tipping, range
must be secured to the floor by sliding rear leveling leg
into the anti-tip bracket.
23