Maintenance - Maytag MGR5710 User Manual

Maintenance (continued)°°°°°°°°°°°,°°°°°°°°°°°°°°°°°°°°°°
Oven Light
CAUTIONS:
• Disconnect power to range betbre replacing light bulb.
. Use a dry potholder to prevent possible harm to hands
when replacing bulb.
• Be sure bulb is cool before touching bulb.
° Do not touch hot bulb with a damp cloth as this may cause
the bulb to break.
Storage Drawer
, Do not store plastic, paper products, food or flam:
mane materials in this drawer, The drawer may
become too warm for these items when the oven is
in use.
Tile storage drawer can be removed to allow you to clean
under the range.
To remove:
To replace oven light bulb:
1. When oven is cool, hold bulb cover in place, then slide wire
retainer off cover. NOTE: Bulb cover will fall if not held in
place while removing wire BaBCOVER
retainer.
2. Remove bulb cover and
light bulb
3. Replace with a40 watt
appliance bulb.
WIRE
4. Replace bulb cover and RETAINER
................. .... secure with wire retainer.
iiiiiiiiiiiiiiiiiiiiiii
5. Reconnect power to range.
Reset clock.
iiiiiiiiiiiiiiiiiiiiiii
Leveling Legs
'"'"'"'"'"'"'"" CAUTION.
, Be Sure the anti-tip bracket secures one 0fthe rear
leveling !egs to the floor t0 prevent the range fr0m
accidentally tipping.
The range should be leveled when installed. If the
range is not level, turn tile plastic leveling legs,
located at each corner of the range, until ral-lge
isle<
.... 19
1. Empty drawer and pull out to the first stop position.
2. Lift up the front of the drawer.
3. Pull out to the second stop position.
4. Grasp sides and lift drawer up and out.
To replace:
1. Fit the ends of the drawer glides into the rails in the
range.
2. Lift up front of drawer and gently push in to the first
stop position.
3. Lift drawer up again and push until drawer is closed.
Electrical Connection
Appliances which require electrical power
are equipped with a three-prong
grounding plug which must be
plugged directly into a properly
grounded three-hole 120 volt elec-
trical outlet.
Always discom,ect power to appliance before sel*vicing.
The three-prong grounding plug offers protection against
shock hazards. DO NOT CUT OR REMOVE THE
THIRD GROUNDING PRONG FROM THE
POWER CORD PLUG.
If an ungrounded, two-hole or other type electrical outlet
is encountered, it is the personal responsibility of the
appliance owner to have the outlet replaced with a
properly grounded three-hole electrical outlet.