Reference: Lt2002 Cloning Procedure Troubleshooting - LG 22LG3DCH Owner's Manual

REFERENCE: LT2002 CLONING PROCEDURE
TROUBLESHOOTING
_1_ Warning: Do not use LT2002 while any PPVcard is
installed in TV or clone programmer will be damaged.
Reset Clone After Static Shock
After replacing exhausted batteries, or if the programmer
behaves strangely after a static shock, use a paper clip or
similar instrument inserted through the small hole marked
"RESET" to activate the internal reset switch and restore
normal operation. After a reset, check the real-time clock
setting. It may be necessary to reset the Clone
Programmer clock from a TV containing the correct time.
Note
The LT2002 programmer is designed to be used with
TVs containing the 221 -01006 and later processors. Use
with earlier TV sets may give unpredictable results.
Processors used before the 221-01006-04 have a limited
screen display capability. They cannot display entire
screens as shown in the quick setup instructions accom-
panying the LT2002 clone programmer. Use the printed
menu illustrations on the quick setup sheet supplied with
the Clone as an aid to making your programming choices.
(Although the menus are not all displayed, the clone
functions all operate normally.)
Clone Programmer Troubleshooting
,_Only usean LGInstaller r emoteto operate cloneprogrammer with TV.
mmff Connect M.RI. cord properly, assure good connection.
mini TV must be powered On for clone to work.
i,l_ Install 4 fresh AA high-quality alkaline batteries.
ml_ Connect TV to a reliable Analog channel signal source.
i,l_ Set time on a TV, copy time to Clone Programmer.
mini Try a different LT2002 Clone programmer.
m,_ Reset Clone Programmer.
,_Retry cloning again.
mini Wait until procedure complete message is displayed.
mini Cloning is only possible with identical model TVs.
,_ Reread cloning pages to be sure all tasks were performed.
m_ B atteries must remain installed to retain time settings.
m,f_ Disconnect newly-cloned TV from power for 5 seconds.
m
z
E:7
x
01_ After cloning operations are complete, just unplug the LT2002 from the TV.
01_ If the TV does not display a picture on the TV (blank screen) after a few seconds, just change channels.
113