Reference: Lt2002 Cloning Procedure Troubleshooting - LG 42700H - 42INCH CLASSHDTV Technical Manual

REFERENCE: LT2002 CLONING PROCEDURE
TROUBLESHOOTING
Warning: Do not use LT2002 while any PPV card is
installed in TV or clone programmer will be damaged.
Reset Clone After Static Shock
After replacing exhausted batteries, or if the program-
mer behaves strangely after a static shock, use a paper
clip or similar instrument inserted through the small
hole marked "RESET" to activate the internal reset
switch and restore normal operation. After a reset,
check the real-time clock setting. It may be necessary
to reset the Clone Programmer clock from a TV con-
taining the correct time.
Note
The LT2002 programmer is designed to be used with
TVs containing the 221-01006 and later processors.
Use with earlier TV sets may give unpredictable results.
Processors used before the 221 -01006-04 have a lim-
ited screen display capability. They cannot display
entire screens as shown in the quick setup instructions
accompanying the LT2002 clone programmer. Use the
printed menu illustrations on the quick setup sheet
supplied with the Clone as an aid to making your pro-
gramming choices. (Although the menus are not all dis-
played, the clone functions all operate normally.)
Clone Programmer Troubleshooting
>
m
z
x
I,l_ P ress Reset on clone programmer, redo teach/learn. (Teach/Learn should take a
minimum of 1 minute.)
,,i,i Only usean LG Installer remote to operate clone programmer with TV.
mConnect M.RI. cord properly, assure good connection.
i,i,i TV must be powered On for clone to work.
i,_Install 4 fresh AA high-quality alkaline batteries.
i,_Connect TV to a reliable Analog channel signal source.
i,l_ Set time on a TV, copy time to Clone Programmer.
i,l,, Try a different LT2002 Clone programmer.
i,_Reset Clone Programmer.
,_ Retry cloning again.
i,l,, Wait until procedure complete message is displayed.
i,i,m Cloning is only possible with identical model TVs.
mReread cloning pages to be sure all tasks were performed.
i,l_ Batteries must remain installed to retain time settings.
mm_ Disconnect newly-cloned TV from power for 5 seconds.
,l_After cloning operations are complete, just unplug the LT2002 from the TV.
,l_If the TV does not display a picture on the TV (blank screen) after a few seconds, just change channels.
110