Right Lighting-Board; Prerequisites; Removing The Right Lighting-Board - Dell Alienware Aurora R4 Owner's Manual

Right Lighting-Board

WARNING:
Before working inside your computer, read the safety information
that shipped with your computer and follow the steps in "Before You Begin" on
page 13. For additional safety best practices information, see the Regulatory
Compliance Homepage at dell.com/regulatory_compliance.

Prerequisites

1 Remove the left side-panel. See "Removing the Left Side-Panel" on
page 25.
2 Open the PCI shroud. See "Opening the PCI Shroud" on page 45.
3 Remove the drive-bay shroud. See "Removing the Drive-Bay Shroud" on
page 47.
4 Remove the right-side top panel. See "Removing the Right Lighting-
Board" on page 117.

Removing the Right Lighting-Board

1 Disconnect the right lighting-board cable from the SIDE_R connector on
the master I/O board.
2 Note the right lighting-board cable routing and remove it from the slot on
the computer.
3 Remove the screws that secure the right lighting-board to the right-side
middle panel.
4 Lift the right lighting-board along with its cable away from the right-side
middle panel.
24
Right Lighting-Board
117