Replacing The Media Card Reader - Dell Alienware Aurora R3 Service Manual

1 FlexBay USB cable 2 securing tab
3 Media Card Reader
7. Remove the four screws that secure the Media Card Reader to the FlexBay dock.
8. Slide the Media Card Reader out of the FlexBay dock.
1 Media Card Reader 2 screws (4)
3 FlexBay dock
Replacing the Media Card Reader
1. Follow the instructions in Before You
2. Remove the new Media Card Reader from its packaging. Save the original packaging for storing or shipping the Media Card Reader.
3. Slide the Media Card Reader into the FlexBay dock.
4. Replace the four screws that secure the Media Card Reader to the FlexBay dock.
5. Lift the securing tab and slide the FlexBay dock through the front of the computer until the securing tab snaps into place.
6. Connect the FlexBay USB cable to the FLEXBAY connector on the master I/O board. For more information on the location of the connector, see
Board Components.
7. Close the PCI shroud (see Closing the PCI
8. Replace the left side-panel (see
9. Lift the drive panel towards the top of your computer.
10. Connect your computer and devices to electrical outlets and then turn them on.
Back to Contents Page
Begin.
Shroud).
Replacing the Left Side-Panel).
Master I/O