Removing The Active-Venting Assembly - Dell Alienware Area-51 Service Manual

Removing the Active-Venting Assembly

1. Follow the instructions in "Before You Begin" on page
2. Remove the left side-panel (see "Removing the Left Side-Panel" on page
3. Remove the right side-panel (see "Removing the Right Side-Panel" on
page 16).
4. Disconnect the active-venting assembly cables from the connectors on the
master I/O board.
5. Remove the six screws (three on each side) that secure the active-venting
panels to the active-venting assembly.
6. Remove the active-venting panels.
7. Remove the six screws (three on each side) that secure the active-venting
assembly to the chassis.
8. Pivot the back of the active-venting assembly upwards and lift it off the
chassis.
6.
15).
1 active-venting panels (2)
2 active-venting assembly
CHAPTER 10: ACTIVE-VENTING ASSEMBLY
1
2
3
4
3 active-venting assembly screws (6)
4 active-venting panel screws (6)
055
/
055