Replacing Memory Module(S) - Dell Alienware Area-51 Service Manual

Replacing Memory Module(s)

1. Follow the instructions in "Before You Begin" on page
2. Align the notch on the bottom of the memory module with the tab on the
memory-module connector.
CAUTION: To avoid damage to the memory module, press the memory
module straight down into the memory-module connector while you
apply equal force to each end of the memory module.
3. Insert the memory module into the memory-module connector until the
memory module snaps into position.
NOTE: If the memory module is not installed properly, the computer may
not boot.
4. If you insert the memory module correctly, the securing clips snap into the
cutouts at each end of the memory module.
5. Close the left-side panel.
6. Connect your computer and devices to electrical outlets, and then turn
them on.
6.
1 memory-module connector
2 tab
3 notch
CHAPTER 5: MEMORY MODULE(S)
5
4
3
2
1
4 securing clips (2)
5 memory module
027
/
027