DriveBeltRemoval A ndReplacement
•
Disconnect the spark plug wire and ground it
against the engine.
•
Drain the fuel tank or place a piece of plastic
beneath the cap to prevent gasoline leakage.
•
If unit is tipped for easier access to belt, tip the
string trimmer mower back on its side to keep
engine spark plug side up.
•
Remove carriage screws, washers, and hex nuts
that secure the trimmer deflector to the base.
See Figure 10.
•
Slide trimmer deflector off so spindle assembly
goes through hole in deflector.
Carriage Screws
Carrlz
• Screws
Deflector
Spindle
Assembly
Figure 10
•
Remove lock nut that secures idler bracket keeper
and idler pulley to idler bracket assembly and
remove keeper.
See Figure 11.
•
Slip the belt around engine pulley and then the
spindle assembly.
Idler Bracket
1
Keeper
Lock Nut
Figure 11
•
Reinstall new belt around pulleys and reconnect
idler pulley and idler bracket keeper to the idler
bracket assembly,
•
Reattach trimmer deflector to trimmer base.
•
Reattach spark plug wire to spark plug.
StoringYourStringTrimmerMower
•
Clean the equipment thoroughly.
•
Wipe equipment with a oiled rag to prevent rust.
•
Refer to engine manual for correct engine storage
instructions
•
Store unit in a clean, dry area. Do not store next to
corrosive materials such as fertilizer.
•
For more compact storage, store unit in the
shipping position with the upper handle folded
toward engine. See ASSEMBLY
section for details.
12