Attaching The Chipper Chute; Attaching The Bag - MTD 24A-462G729 Operator's Manual

b. Placesecondspaceroverhex bolt insideother
hingeand securewith hex lock nut.
c. Securebothsides of chutedeflectorto impeller
housingusingwingknobspreviouslyremoved.
Attaching The Chipper Chute
5. a. Removethe threecuppedwashersand hexnuts
from weldstudsaroundthe openingon the side of
the impellerhousing.See Figure5.
b. Removethe hexbolts,flat washers,and lock nuts
from the two holeson the upperend of the support
brace.
6. a. Align the chipperchute overthe weldstuds, sothe
slot in the bottomof the chuteis facing down.
b. Securechipperchute with the threecupped
washers(cuppedsideagainstthe chipperchute)
and hexnuts previouslyremoved.Do nottighten
the nuts at this time. See Figure6.
7. The chippershredderwas shippedwith one end of
the support bracealreadysecuredto the lowerframe.
Loosenbutdo not removethe bolts securingthe brace
to the frame.See Figure7.
a. Align the holesin thechute with the holesin the top
of the braceand attachbraceto chipperchutewith
hardwarepreviouslyremoved.Tightensecurely.
b. Tightenthe bolts securingthe support braceto the
frame.
c. Tightenthe threenuts on the weldstuds holding
the chipperchute to the impellerhousing.
Attaching The Bag
8. Toattachthe bag:
a. Placethe openingof the bag completely over the
chute deflector.
b. Pullon the drawstringuntilthe bag is tight around
chute deflectoropening.
c. Clipdrawstringback on itself,tight againstchute
deflectorto secureintoposition.See Figure8.
.//
Figure 5
f
/
/
/
i
/
i
i
/
/
/
/
/
/
/
/
/
i /
/ /
/
/
/
J
Figure 6
Figure 8 Figure 7
/
/
i
i
i s
/
Your Chipper
Sh redder
ii i _iI_ ii
7