Assembling Your Chipper Shredder Vacuum - MTD Series 020 Operator's Manual

_, ARNING - YOUR RESPONSIBILITY:
Restrict the use of this power machine to persons who read,
understand and follow the warnings and instructions in this manual and on the machine.
NOTE: Not all safety labels shown may apply to your model chipper shredder vacuum.
STOP
TO AVOID SERIOUS iNJURY
• READ OPERATOR'S MANUAL.
• KEEP HANDS OUT OF iNLET AND DISCHARGE OPENINGS WHILE MACHINE
iS RUNNING. ROTATING BLADES ARE iNSiDE.
" TURN ENGINE OFF AND ALLOW iMPELLER TO COME TO COMPLETE STOP
BEFOREREMOVING BAG.
® DONOT A'R'EMPT TO CLEAR A CLOG OR JAM WiTH THE ENGINE RUNNING.
= DONOTOPERATEUNIT WffHOUT BAG OR OFnONAL BLOWER CHUTEiN PLACE,
• DONOTSTANDOR WALKiN FRONTOF BLOWERCHUTEOR NM ff ATBYSTANDERS,
OBJECTS THROWN OUT OF DISCHARGE CAN CAUSE PERSONAL iNJURY.
® DONOT OPERATE WHEN CHILDREN OR OTHERS ARE AROUND.
• WEAR APPROVED SAFETY GLASSES.
SECTION 2: ASSEMBLING Y OUR CHIPPER SHREDDER V ACUUM
IMPORTANT: This unit is shipped without gasoline or oil
in the engine. Be certain to service engine with gasoline
and oil as instructed in the separate engine manual
before operating your machine.
NOTE: Reference to right or left hand side of the
chipper shredder vacuum is observed from the
operating position.
LoosePartsIn Carton
(SeeFigure1)
• Handle Assembly
• Bag
• Blower Chute (on models so equipped)
Disconnecting S parkPlugWire
Before setting up your chipper shredder vacuum,
disconnect the spark plug wire from the spark plug and
ground to a stud on the engine.
/
Blower Chute
Wing
Nuts
Handle
Screw
Bag
Figure 1