Assembling Your Chipper Shredder - MTD 463 Operator's Manual

WARNING: - YOUR RESPONSIBILITY: Restrict the use of this power machine to persons who read,
understand and follow the warnings and instructions in this manual and on the machine.
NOTE: Not all safety labels shown may apply to your chipper shredder.
WARNINGi DO NOT OPERATE
TH_S MACHMNE
UNLESS
THE
CHUTE DEFLECTOR HAS BEEN
PROPERLY iNSTALLED AND _S
SECURED WiTH THE HAND
KNOBS,
SECTION 2: ASSEMBLING YOUR CHIPPER SHREDDER
IMPORTANT:This unit is shipped without gasoline or oil
in the engine Be certain to service engine with gasoline
and oil as instructed in the separate engine manual
before operating your machine
NOTE: Reference to right or left hand side of the
chipper shredder is observed from the operating
position.
Removing UnitFromCarton
• Remove staples, break glue on top flaps, or cut
tape at carton end and peel along top flap to open
carton
• Remove loose parts if included with unit (ie,
operator's manual, etc.)
• Cut along corners, lay carton down flat, and remove
packing material
• Roll or slide unit out of carton and check carton
thoroughly for loose parts
LoosePartsIn Carton
(SeeFigurel)
• Hopper Assembly
• Discharge Chute
• Chipper Chute (463 thru 465)
• Bag (Not Shown)
• Tamper Plug (If Equipped)
Disconnecting S parkPlugWire
Before setting up your chipper shredder, disconnect the
spark plug wire from the spark plug and ground against
the engine
Dis, _arge
Chute
Assembly
Chipper
Chute
Figure 1