Mitsubishi TS-4545 Owner's Manual page 45

Using the remote control to operate VCRs, cable
boxes and other components (cont.)
[>Important:
_Important:
notes about your remote control
Sometimes manufacturers will change their products, or Lhey may
use more than one code. If this is the case, your remote may not be
able to operate your VCR or cable box.
When you replace the batteries in your remote control, the remote
will usually return to its initia] setting. You may need to set up
your remote again.
using your remote control to operate your Mitsubi,_hi
laserdisc player
After you have set up your remote control for your laserdisc player,
you can use the remote to operate the player.
O Use the select switch on the remote control to choose the cable
layer.
Point the remote control at the laserdisc player and press the
desired buttons.
You can use the POWER, CHANNEL, numbers (0-9), INFO,
MENU, CANCEL, STOP, PAUSE, REW:_ PLAY, and FF tmttons to
operate your laserdisc player.
using your remote control to operate your Mitsubishi audio
products
After you have set up your remote conrzol for your A2€"receiver, you
can use the remote to operate it.
O Use the select switch on the remote control to choose the layer
that you set up to operate your receiver: TV or C._BLE.
Point the remote control at the A/V receiver and press the
desired buttons.
If you are using a Mitsubishi HTS-100, you can use the POWER,
VOLUME, and MUTE buttons to operate the receiver.
If you are using a Mitsubishi HTS-300, you can use the POWER,
CHANNEL, INPUT, VOLUME, ENTER:. numbers (0-9), INFO,
MENU, CANCEL, AUDIO, VIDEO, ADJUST, and MUTE buttons
to operate _he receiver.
If you are using a Mitsubishi M-VR400 or M-VR600, you can use
the POWER, VOLUME, numbers (0-9}, and MUTE buttons to
operate the receiver.
If you are using the Mitsubishi M-CD500 CD changer, you can use
the PLAY, PAUSE, STOP, FF, and REW buttons to operate the
changer.
Getting Started 45