Dvd Tovideotape Duplication - Magnavox MRD500VR Owner's Manual

DVD to Videotape Duplication 41
• m• • • • • • too • •e• • • • • • • • • • • • • • • • • •• •too• •• • • • •• e• 1• •• • e• •1 • • •too • • • o• • • •• • o• • • • • • • •1 • •• • Jet to too • •o • ••eoo• Q. 1• • •o
Follow the steps below to copy a DVD to a videotape.
This will be possible only if the DVD is not copy protected.
Before you begin:
• Put a videotape in the cassette compartment. Make sure the tape's
record tab is intact and the tape is long enough to record the
DVD.
• Put the DVD you want to copy in the disc tray.
• PressVCR so the redVCR light appears on the front of
the System•
• Turn on the'IV.
Point the remote control at the System. Press Number
buttons 0, 0,3._'DISC '' will appear on theTV screen in the
top right corner briefly.The DVD logo will also appear.
DFEO ]
Press MODE/SPEED until the desired tape speed (SP
or SLP) appears briefly in the lower left corner of the
TV screen. Details about tape speed are on page 77.
3
4
5
6
Press REC • to start recording.The red RECORD light
will appearon the front of the System.
Press DVD. Press PLAY I_ to play the DVD.
To pause the recording, pressVCR_then press PAUSE I I
once. The red RECORD light will flash.To resume
recording, press REC • or press PAUSE I I again. The
red RECORD light will come on again.
To stoprecording, pressVCR, then press STOP l.
|
A Timer Recording is not possible
during DVD to Videotape
duplication.
You cannot select Tuner mode
during DVD to videotape
duplication.
The recording will not be clear if
the DVD has copyright protection.