Automatic Operation Features - Magnavox MRD500VR Owner's Manual

46 Automatic Operation Features
The following tape features are available inVCR mode. PressVCR so
the redVCR light is on, if necessary.
Automatic Playback
When you put a tape in the System, the power will come on. If the
tape's record tab is missing, playback will begin.
If a timer recording is set and the TIMER REC light is flashing,the
power will not come on automatically when you insert a tape with
the record tab intact.
If a timer recording is set and the TIMER REC light is flashing,the
System will eject the tape if the record tab is missing.
Automatic Rewind, Eject
When a tape is playecf, f ast forwarded, or recorded to its end, the
tape will rewind to the beginning, stop, and eject.
This feature does not operate if AUTO REPEAT is ON. Details are on
page 42.
Tape Eject
A tape can be ejected with the System power on or off (but the
System's power cord must be plugged in).
If a timer recording is set and theTIMER REC light is On, pressing
STOP/EJECT HA__will turn on the System and/or cancel the timer
recording.The TIMER REC light will turn off. Press STOP/EJECT IE A
again to remove the tape. Remember to insert a tape and press
TIMER SET to reset the timer recording.
Automatic Tracking Adjustment
TheVCR adjuststracking automatically to giveyou the bestpossible
picture quality.With some recordings,however, y ou mayget a better
picture using manualtracking (see below).
Manual Tracking
To adjust the tracking during normal and slow motion playback, press
SKIP _/CH A or SKIP 1441/CH v on the remote.
Tracking will return to Automatic Tracking when you press STOP •
or insert a tape.
Furthermore, you can press SKIP _/CH A or SKIP _/CH v
to remove vertical jitter in a Still picture.
Before _)1__ After
Tracking Tracking
Adjustment Adjustment