Philips LX9000R Addendum Manual page 59

2
3
4
5
6
7
8
9
ID Features
Switch yourTV set on. If necessary set the TV to the
correct audio/video channel, Such channels may be called
AUX or AUXILIARY IN, AUDIO/VIDEO orA/V IN, EXT1,
EXT2 or EXTERNAL IN, etc,These channels are often near
channel 00,
PressSYSTEMMENU on the remote control,
-_ The systemmenu bar appears,
Press • on the remote control as often as necessary until
t_ iS selected.
Press • on the remote control to confirm,
Press • or • on the remote control as often as necessary
until G} Features is selected,
Press • on the remote control to confirm the selection,
Press •, • on the remote control as
often as
necessary to
select the desired function,
Press • on the remote control to confirm the selection,
Press •, • on the remote control as
often as
necessary to
select the desired setting.You can choose as follows:
Access control
See separate chapter "Access control",
Status box
With OSD (On Screen Display)not only screen menus,but
also information on the current operatingstatus(counter,
playback, r ecordingTV channel,,,) are displayedon theTV
screen.Youcan switch offthe OSD information to avoid
recording it when recording from the DVD recorder system
to an additionalappliance,
On:The OSD information appears in every selected
mode for a few secondsand disappearsagain,
-_ Off, The OSD information is switched off and is no
longer displayedon the TV screen,
Auto resume
If playback was interru_ed on a premecorded DVD-Video
disc orVideo CD disc, playback will start after reloading at
exactly the same position where it was interrupted.This
applies not only to the current disc but to the last 20 discs
played,
•_ On:The function is switched on,
•_ O@The function is switched off,
Low power standby
You can switch offthe clock displayon the DVD recorder
systemto savepower Programmed recordings will
nevertheless be executed.
On: If the DVD recorder system is switched to standby
by pressing (_) on the remote control, the dock
display is switched off,
-_ O_ if the DVD recorder system is switched to standby
by pressing _ on the remote control, the clock
display is still visible.
User preferences
10
11
PBC
This line only appears if a (Super)Video CD isinserted,
With this settingyou can activate or deactivate the PBC
menu (see"Playinga (Super)Video CD"),
Press OK on the remote control to confirm the new setting.
Press • on the remote control to end.
1
2
3
4
5
Remote control settings
Switch yourTV set on. If necessary set the TV to the
correct audio/video channel, Such channels may be called
AUX or AUXILIARY IN,AUDIO/VIDEO orAN IN, EXT1,
EXT2 or EXTERNAL IN, ere,These channels are often near
channel 00.
PressSYSTEMMENU on the remote control.
._ The systemmenu bar appears.
Press • on the remote control as often as necessary until
TA is selected.
Press • on the remote control to confirm,
Press • or • on the remote control as often as necessary
until @Remote control settings is selected.
6
Press • on the remote control to confirm the selection.
7
Press • again on the remote control to confirm,
8 Press •, • on the remote control as often as necessary to
select the desired setting, You can choose as Follows:
Remote control used
You can set the remote control type to which your
DVD recorder system should respond to:
-_ DVD player:The DVD recorder system responds
additionally to a DVD player remote
control (remote control code RC-6),
Choose this setting if the remote control of
your PhilipsTV set supports DVD Functions.
-_ DVD recorder:The DVD recorder system responds
only to the supplied remote controk
9 Press OK on the remote control to confirm the new selting.
|0 Press • on the remote control to end.
57