KitchenAid KICU465SWH0 Installation Instructions And Use & Care Manual page 10

4. Install the 2 vent extension pieces onto the diverter by gently
pushing them until they stop,
A
A. Vent extensions
5. Discard the lower chimney cover shipped with the hood and
use the cover from the Non-vented (recirculating) Kit
(purchased separately).
6. Slide the recirculating kit lower chimney cover over the
chimney support and the upper cover.
Check that the diverter extensions line up with the openings
in the cover. Attach the cover using the 2 screws provided.
7. Snap vent grills into place.
"'_..;;;;" _ ...... C222LLL222; ....
. ,?'-_'=L ......
A. Vent grill location
Chimney Extension Kit Installation (Optional)
1. Remove the plastic covering from the chimney covers,
2. Discard the upper chimney cover supplied with the hood.
3. Slide the chimney cover provided with the extension kit over
the lower chimney support and extension frame and secure
to the top of the extension frame using the 2 screws
provided.
A. Screw
B, Upper chimney extension cover
C. Lower chimney extension cover
4.
2.
3.
Slide lower chimney cover over the chimney support and
extension chimney cover and attach to the bottom of the
support using the 2 screws provided.
A
A. Chimney extension kit assembled to hood
assembly with chimney covers attached
Lift the hood up against the chimney support and attach the
canopy to the support with 4 bolts provided, Tighten bolts
securely,
A
A. Chimney support
B. Hood
C. Bolts
From the underside of the hood, plug control cables together
as shown,
Insert each connected cable into a black plastic connector
box half.
10