Page 1
iMPORTANT: Quick Reference Table of Contents: Read and save Pages these instructions. Before you start Product dimensions Cabinet dimensions iMPORTANT: Venting requirements Electrical requirements installer: Leave Installation instructions with the homeowner. [_=[] installation steps Homeowner: Keep Installation Instructions for Use and Care information future reference.
Parts needed: WARNING -- TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, 2 U.L.- or C.S.A.- listed, 112" (12.5 mm} OR INJURYTO PERSONS, conduit connectors OBSERVE THE FOLLOWING: Your safety and the safety of power supply cable Installation work and electrical others is very important.
Venting methods Vertical roof venting Horizontal wail venting This island canopy range hood is factory set for venting through the roof roofcap or wall. For non-vented (recirculating) 3-1/4" x 10" installations, see "Non-Vented cm x 25 cm) 3-1/4" x 10" wall (Recirculating) Kits"...
supply cable. Wire sizes (COPPER separate 15-amp circuit, fused on important: Observe all governing both sides of the line. WiRE ONLY) and connections must codes and ordinances. conform with the rating of the Do not ground to a gas pipe. it is the customer's responsibility: appliance as specified on the Check with a qualified...
Electrical Alignsupport m ounting bracket '10[] Remove the terminal box withholes in ceiling. Attach support connection cover from the range hood. Remove system frame toceiling using anchors the power supply cable knockout recommended foryourtypeofceiling: using a flat-blade screwdriver. Do not •...
Page 7
install chimney Check operation sections upper 17. Turn power ; , ney n Connect vent to damper or hood and seal all connections with duct tape. chimney holes upper chimney lower support '2ney system frame clips_[_ control panel location chimney holes The island canopy hood controls are located in a grey panel on...
WARNING -- TOREDUCETHE DONOTUSE WATER, including RISKOFFIRE, E LECTRIC SHOCK, wet dishclothsor towels-- a ORINJURYTO PERSONS, violent steamexplosion will o I r- 01e OBSERVETHE FOLLOWING: result.Useanextinguisher ONLY if: mllmlml Usethis unit only in the manner intendedby the manufacturer. If Youknowyou havea Class ABC r'_Ol you havequestions, c ontactthe extinguisher, a ndyou already...
Maintenance Replacing the light bulb: This range hood uses fluorescent lamp type F33-15W-T8 and starter type 52. Remove the retainer clips from both ends of the light cover. Carefully slide the cover all the way to the right. Then lower the left end of the glass below the support flange and remove the glass by sliding it back from the left.
Page 10
YOU SPECIFIC LEGAL RIGHTS AND YOU MAY ALSO HAVE OTHER RIGHTS, WHICH VARY FROM STATE TO STATE OR PROVINCE TO PROVINCE. Outside the 50 United States and Canada, this warranty does not apply. Contact your authorized KitchenAid dealer to determine if another warranty applies.
KitchenAid These parts will fit right and work right, because Factory Service at 1-800-442-1111. they are made to the same exacting specifications used to build every new KitchenAid* appliance. For further assistance If you need further assistance, you can write to...
Page 12
KitchenAid Canada with any questions or concerns at: correspondence. Consumer Relations Department KitchenAid Canada 1901 Minnesota Court Mississauga, Ontario L5N 3A7 4329223/9763387 '_)2005 KitchenAid Printed in Italy 10/2005 ',qP Registered trademark/ ' trademark of KitchenAid, U.S.A., KitchenAid Canada licensee in Canada...
Need help?
Do you have a question about the KICU265HSS1 and is the answer not in the manual?
Questions and answers