KitchenAid KHSU265WBA0 Installation Instructions And Use & Care Manual page 43

7=
8.
g.
Measure the thickness of the cabinet floor, including the filler
strips, if used. If the thickness is less than 5/8"(15.9 mm),
install wood filler strips that are a minimum length of
5" (12.7 cm) onto the cabinet floor. The mounting bracket
adjusts from %" (15.9 mm) to 21/8"(54.0 mm) for the wood
filler strips.
B
A. Less than %" (15.9 mm)
B. Wood fillers (thickness as required)
The spring loaded brackets are factory set to accommodate a
thickness between 13As"(3.0 cm) and 21¼ '' (5.7 cm). If your
cabinet bottom is less than 1¾e" (3.0 cm) thick, the spring
loaded brackets can be removed and repositioned down from
the top setting (A), to the bottom setting (B), by removing the
4 Phillips screws.
...... _"J/ P"
A
:_ ....
B 0
/\/o_ 0 .................................................
B
....... ............................................ A
g ................................................. _ ..................................
A. Top setting - factory installed
B. Bottom setting
Place the round damper into the vent opening of the range
hood and press down. If the roof cap or wall cap has a
damper, do not attach the damper to the range hood.
10. Place the range hood on its back side on a covered surface.
a} Slide the range hood screen forward.
b} Remove the metal grease filters. See "Range Hood Care"
section.
c} Screw the mounting brackets up to the top position.
I
[
A. Mounting bracket screw
B. Flat-blade screwdriver
NOTE: For some non-vented (recirculating) installations it
may be easier to attach the vent system to the range hood
before lifting the range hood into its final location. Seal the
connection with clamps.
Excessive Weight Hazard
Use two or more people to move and install
range hood.
Failure to do so can result in back or other injury.
1. Using 2 or more people, lift the range hood into its final
position. (The wiring and terminal box are to be on top of the
range hood.)
2. Check that the mounting brackets overlap the cabinet bottom
or wood filler strips.
3. Center the range hood.
A. Damper
B. Range hood screen
C ........................... I;
o ©
E
I
A. Mounting bracket
B. Optional wood rifler strip
C. Cabinet bottom
D. Optional wood rifler strip for recessed cabinet
E. Slide-out range hood
11