Table of Contents
Advertisement
Thread chain cutter
After finishing the seam, sew an approx.
6" -8" (15 -20 cm> long thread chain. Pull
the thread chain from the back to the front
over the thread chain cutter 40. This will cut
off the thread chain.
Cbmp spring for serging thread chain 32
Using this feature you can serge the thread
chain at the start of the fabric, by pulling it
into the seam. Stitch off a minimum 4"
(10 cm> long thread chain and raise the
presser foot. Remove the thread chain care
fully from the swiveling stitch width latch
27. Pull the thread chain forwards and
clamp it under the spring.
This feature cannot be used for either the
five-thread safety-stitch seam, the four-
thread safety-stitch seam, the two-thread
chainstitch or for the rolled hem.
I
Place the fabric right in front of the
needle(s). If necessary, make an approx.
1.5" (3cm> cut into the fabric along the
cut-line using a pair of scissors. Lower the
presser foot and start sewing. The thread
chain pulls automatically into the inside of
the seam.
Note:
30
Hide quick links:
Advertisement
Table of Contents
