Table of Contents
Advertisement
Panasonic Electric Works Nordic AB
MEW01091
28.2
Action
"Access"
Scroll to menu A2
"A"
Depending on if "0" or
"1" is chosen, one of
the following will be
shown:
"A"
Rev: 3
Disconnect / Re-connect zone line input
(H5/A2)
To avoid damage on the units and EBL128 during physical connection
/ disconnection of units, it is highly recommended to have the zone
line disconnected (disabled), i.e. voltage free (dead).
Disconnected (disabled) zone line input is indicated by LED "Disable-
ments" and is listed in menu H4/U1.
Text in display
Disconnect / Re-connect COM loop
Disconnect / Re-connect zone line input
Disconnect (=0) or Re-connect (=1) zone
line input? 1
Disconnect zone line input 0 expansion
board 0
Re-connect zone line input 0 expansion
board 0
Disconnect (=0) or Re-connect (=1) zone
line input? 1
Disconnect / Re-connect zone line input
EBL128 Operating Instructions V1.1.x
ACCEPT? A1
ACCEPT? A2
ACCEPT?
ACCEPT?
ACCEPT?
ACCEPT?
ACCEPT? A2
106
Comments
According to chapter
"Access code for service
and maintenance", see
page 104.
Write "0" or "1" and press
"A" to accept.
Write the 4580 board no.
(0-7) and the zone line
input no. (0-7). Press "A"
to accept.
Write "0" or "1" and press
"A" to accept or press
"Return" menu A1.
Scroll or press "Return" to
H5. Scroll or press
"Return" to log off.
Advertisement
Table of Contents
