Rinse Agent Dispenser - Kenmore 15569 Owner's Manual

Problem
Dishwasher
will not stas't
Dishwasher will
not fill with water
Unusual noise
Dishwasher leaks
Detergent cup lid
won't latch after
adding detergent
Dishes not dry
Caused by
Dishwasher not receiving
electricity,
Dial not in correct
position for cycle selected
No water supply
Water inlet valve dogged
Improper loading
Dishwasher not level
Too much sudsing
Spilled rinse agent
Cycle Indicator Dial not
in OFF position
Water is not hot
MR DRY option
selected
Impioper loading
Rinse agent
dispenser empty
Solution
Check house fuse or circuit breaker_
Make sure Cycle Indicator Dial is turned
f_ enough
and
cycle button is fully pushed in.
Make sure water supply valve under sink is turned on.
Water' valve supply line may be clogged with sediment.
Clean out.
Utensils may not be secure on rack pins, or something
small may have dropped from the rack° Water is causing
utensils to rattle,. Make sure everything is securely placed
in dishwasher.
Level dishwasher as described in Installation Instructions,
Do not place dishwasher on carpet.
Improper' detergenL Use automatic dishwasher detergent
only or try a different brand or less detergent.
if hand dishwashing detergent is used by mistake, pour one
measuring cup of vegetable oil in bottom of tub and run
dishwasher through a complete NORMAL WASH cycle with
recommended amount of automatic dishwashing detergent.,
To remove suds from tub: Open dishwasher. Let suds
evaporate. Add 1 gallon of cold water to tub. Close and latch
dishwasher. Pump out water by slowly turning Cycle Indicator
Dial until a drain period is reached, Repeat if necessary.
Spilled rinse agent can cause foam during washing. This
can lead to overflowing. Wipe up accidental spill of rinse
agent with a damp cloth,,
Cycle Indicator Dial must be in OFF position for cup lid to
close and latch properly. If you unlatch the door and open
it to dry your dishes, the Cycle Indicator Dial does not
advance to OFF by itself
Raise water heater thermostat to 140°E if necessary:
Do not select MR DRY drying option, Mlow dishes to
dry in heated air.
Load dishes so items drain properly. Avoid overloading.
Fill rinse agent dispenser' if empty.
(contimted next page)
13