Cookingzone Heatsfood Toohot Or Not Enough; Fooddoes Not Heat Evenly; Poorcookingresujts; Cooktopzonecontroldisplayseand 2 Digitsled Maincontroldisplaysdo. 0 3. Off.o5.B5 Or O - Electrolux E30IC80ISS1 Use & Care Manual

Solutions to Common Problems
COOKmNG ZONE H_TS FOODTOO HOT OR NOT HOT ENOUGH
[] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] []
• Incorrect power level setting. Adjust the power level setting higher or lower and refer
to recipe for guidance and adjust accordingly.
FOOD DOES NOT HEAT EVENLY
[] [] [] [] [] [] [] [] _ [] [] [] [] [] [] [] [] _ [] [] _ []
• Lightweight or warped pans were used. Be sure to use good quality cookware.
• Use only flat bottom, evenly balanced medium or heavyweight cookware. Heavy and
medium weight pans heat evenly. Because lightweight pans heat unevenly, foods may
burn more easily (See pages 11 to 13 for further information).
• Adjust Cooking Zone power level setting until the proper amount of heat is obtained.
POOR COOKING RESULTS
[] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] Iii []
• Many factors affect cooking results. Adjust the recipe's recommended power levels or
cooking times.
• Cookware is too lightweight or warped. Use heavier quality cookware so foods being
prepared may cook more evenly.
HC_
COOKTOP ZONE CONTROLS DmSPLAY cL-f A ND A 2
DmGmTS ERROR CODE
[] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] []
• Induction Cooktop main control has detecteda fault or error condition. Try turning
electrical power supplyOFF and back ON to cooktopinorderto reset Cooktop main
controls. If fault recurs, r ecord fault number and turnpower supplytoCooktop OFF.
COOKING ZONE LED CONTINUOUSLYFLASHES F
[] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] []
• Induction Cooktop pan detection sensors do not see the correct cookware. Test with a
magnet to be sure cookware is made with Induction compatible material.
• Cookware has been removed from the Cooking Zone without turning the Cooking Zone
OFF. Place cookware back on to the Cooking Zone or if finished cooking turn of the
affected Cooking Zone.
• Cookware is not centered over the Cooking Zone properly. Refer to page 12 for correct
cookware placement.