Table of Contents
Advertisement
Available languages
Available languages
INSTALLATION INSTRUCTIONS
6. Pull on handle to slide air conditioner
out of cabinet. Place air
conditioner
on cardboard.
Excessive Weight Hazard
Use two or more people to move and install
air conditioner.
Failure to do so can result in back or other injury.
Remove
packaging
materials
•
Remove and properly dispose of packaging materials.
Remove tape and glue residue from surfaces before turning
on the air conditioner. Rub a small amount of liquid dish soap
over the adhesive with your fingers. Wipe with warm water
and dry.
•
Do not use sharp instruments,
rubbing alcohol, flammable
fluids, or abrasive cleaners to remove tape or glue. These
products can damage the surface of your air conditioner.
•
Handle air conditioner
with care.
1. Remove air conditioner from carton and place on cardboard.
2. Remove shipping screw from side wall of cabinet.
A
A. Shipping screw
3. Pull off control knobs (on some models).
4. Remove front panel from air conditioner
and set aside.
5. Remove ground screw and ground wire from front of air
conditioner
base. Save ground screw.
A. Green ground wire
B. Ground screw
A. Handle
NOTE: Do not lift, push, pull or remove any expanded
polystyrene (foam) from inside the air conditioner.
It is not
packing material.
NOTE: Handle air conditioner
with care.
Window installation
(on some models}
NOTE: Attach top channel and side curtains to air conditioner
cabinet before placing cabinet in window.
1. Locate supplied bag of screws.
2. Place top channel on top of air conditioner cabinet, lining up
the 3 holes in top channel with the 3 holes on top of air
conditioner
cabinet.
3. Using 3 - #10 - 12 x %" pan-head Phillips screws, attach top
channel to air conditioner cabinet.
B
A
B
B
A. Top channel
B. #10 - 12 x _" pan-head Phillips screws
4. Insert top and then bottom of right-hand curtain housing in
top and bottom curtain guides on air conditioner
cabinet.
Advertisement
Table of Contents
