Air Conditioner Use; Starting Your Air Conditioner - Crosley CAH8WRR0 Use & Care Manual

5. Remove the2front p anel screws from airconditioner base.
6. Insert front t abs offront p anel intotopofcabinet andswing
front i ntoplace.
7. Attach bottom front o fpanel withfront p anel screws. Replace
control knobs ( onsome models).
NOTE: Route p ower s upply c ordthrough n otch infrontpanel.
\
A. Front panel screws
B. Power supply cord notch
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in
death, fire, or eJectricaJ shock.
8. Plug into a grounded 3 prong outlet.
g. Press RESET on the power supply cord plug.
AIR CONDITIONER USE
Operating your air conditioner properly helps you to obtain the
best possible results.
This section explains proper air conditioner operation.
IMPORTANT:
• If you turn off the air conditioner, wait at least 3 minutes
before turning it back on. This prevents the air conditioner
from blowing a fuse or tripping a circuit breaker.
Do not try to operate your air conditioner in the cooling mode
when outside temperature is below 65°F (18°C). The inside
evaporator coil will freeze up, and the air conditioner will not
operate properly.
NOTE: In the event of a power failure, your air conditioner will
operate at the previous settings when the power is restored.
• CLOSED--to circulate room air
CLOSED
OPEN
NOTE: The Exhaust control will function only when the Fan
Control is operating.
Style 1 --Cool only air conditioner settings
1. Remove clear protective film from front panel badge (on
some models).
2. Set the Exhaust control. See "Exhaust Control (on some
models)."
3. Set the Fan Control to desired setting. See "Fan Control" for
your model.
4. Turn the Thermostat control to a mid-setting. See
"Thermostat" for your model.
Exhaust Control (on some models)
Fan Control
Set the Fan control to the desired setting. When the air
conditioner is operating at Low Cool, High Cool, or Turbo Cool,
the fan circulates air continuously.
• Turbo Cool--for maximum cooling
• High Cool--for normal cooling
• Low Cool--for sleeping comfort
• Fan Only--to move air continuously without cooling
NOTE: Fan runs on Turbo speed only.
Set the Exhaust control to CLOSED for maximum continuous
cooling. The Exhaust control set OPEN allows you to draw stale
or smoky air from the room.
• OPEN--to exhaust room air to the outside
10