Replacing Oven Light - Crosley CRG3480LSD Use & Care Manual

Replacing oven Eght
Be sure the range is unplugged and all parts are COOL before
replacing oven light. Wear a leather=faced glove for protection
against possible broken glass. ......................
The oven light is located at the rear of the glass
oven cavity and is covered with a glass shield shield
held by a wire holder. The glass shield wire
protects the light bulb and must be in place holde
whenever the oven is in use.
To replace the interior oven light bulb
1.
2,
3,
4.
5,
6.
Turn electrical power off at the main source or
unplug the range.
Press wire holder to one side to release the glass
shield that covers the light bulb.
Replace light with a new 40 watt appliance bulb.
Replace glass shield over bulb and snap wire holder back into
place.
Turn power on at the main source (or plug the appliance in).
The clock will then need to be reset. To reset, see "Setting the
clock" in this Use & Care Guide.
Special door care instructions = Host oven doors
contain glass that can break. Read the
following recommendations:
• Do not close the oven door until all the oven racks
are fully in place.
• Do not hit the glass with pots, pans, or any other
object.
• Scratching, hitting, jarring or stressing the glass
may weaken its structure causing an increased risk
of breakage at a later time.
Oven door
hinge
locations
Fig. $
Removing and replacing the lift-off oven door
• To avoid possible injury when removing or replacing the
oven
door,
follow the instructions below
carefully
and
always hold the oven door with both hands positioned away
from the door
hinge
area,
= The door is
heavy. For safe, temporary storage, lay
the door
flat with the inside of the door
facing
down.
TO remove oven door:
1. Open oven door completely (horizontal with floor - Fig.l).
2. Pull the door hinge locks on both left and right door hinges down
from the oven frame completely towards the oven door (Fig. 2).
A tool such as a small fiat-blade screwdriver may be required.
3. Firmly grasp both sides of oven door along the door sides (Do not
use the oven door handle - Fig. 3).
4. Close the door to the broil stop position (the oven door will stop
into this position just before fully closing).
5. With the oven door in the broil stop position, lift the oven door
hinge arms over the roller pins located on each side of the oven
frame (Fig. 4).
To replace oven door:
1. Firmly grasp both sides of oven door along the door sides (Do not
use the oven door handle - Fig. 3).
2. Holding the oven door at the same angle as the removal position,
seat the hook of the hinge arm over the roller pins located on
each side of the oven door frame (Fig. 4). The hook of the hinge
arms must be fully seated onto the roller pins.
3. Fully open the oven door (horizontal with floor - Fig. 1).
4. Push the door hinge locks up towards and into the oven frame
on both left and right oven door hinges (Fig. 2) to the locked
position; then close the oven door.
Oven
Door
Pin
Ning÷
A_m
Hook
Fig. 2
Fig. 3
Fig. 4-