Cautions For Aluminum Use; Replacing The Oven Light - Crosley ELECTRIC RANGE Use & Care Manual

Cooktop cleaning (cont'd)
IMPORTANT
Damage to the ceramic glass cooktop may occur if you
use an abrasive type cleaning pad. Only use cleaning
products that have been specifically designed for ceramic
glass cooktops.
Do not use the following on the cooktop:
• Do not use abrasive cleaners and scouring pads, such as
metal and some nylon pads. They may scratch the
cooktop, making it more difficult to clean.
• Do not use harsh cleaners, such as chlorine bleach,
ammonia or oven cleaners, as they may etch or discolor
the cooktop.
• Do not use dirty sponges, cloths or paper towels, as they
can leave soil or lint on the cooktop which can burn and
cause discoloration.
Caution for aluminum use on the cooktop
• Aluminum Foil - Use of aluminum foil on a hot cooktop
will damage the ceramic cooktop. Do not use thin
aluminum cooking utensils or allow aluminum foil to
touch the ceramic cooktop under ANY circumstances.
• Aluminum utensils - The melting point of aluminum
is much lower than that of other metals. Care must be
taken when aluminum pots or pans are used on the
cooktop. If aluminum pans are allowed to boil dry
when using the cooktop, not only will the utensil be
damaged or destroyed, but it may fuse to, break or
mark the ceramic glass surface, permanently
damaging the cooktop surface.

Replacing the oven light

CAUTION
Be sure the range is unplugged and all parts are COOL before
replacing oven light. Wear a leather-faced glove for protection
against possible broken glass.
The light bulb is located at the rear of the oven and is
covered with a glass shield held by a wire holder. The glass
shield must be in place whenever the oven is in use.
To replace the interior oven light bulb
1. Turn electrical power off at the main source or unplug
the range.
2. Open oven door for access to interior oven light. Once
located, press wire holder to one side to release the
glass shield (See Fig. 1).
3. Replace bulb with a new 40 watt appliance bulb.
4. Replace glass shield over bulb and snap wire holder into
place.
5. Turn power back on again at the main source (or plug
the range back in).
6. The clock will then need to be set with the correct time
of day. To reset, see "Setting the Clock" in this Use &
Care Guide.
glass shield
wire holder
CARE & CLEANING
Fig.1
25