Kenmore 790.3673 Series Use & Care Manual page 24

Slide-in models
Table of Contents

Advertisement

General Care & Cleaning
(cont'd)
Storage
Drawer
Use the storage drawer for storing cooking utensils. The drawer can de removed to facilitate cleaning under the range. Use
care when handling the drawer.
Storage
Roller
Drawer
Front Frame
Removing
and
Replacing
Storage
Drawer
To remove the drawer:
1.
Pull empty drawer out to the roller guide stop.
2.
Tilt the drawer up and pull it out over the rollers.
To replace the drawer:
1. insert the rear end of the drawer into the opening.
2. Fit the drawer end rollers onto the guide rails.
3. Push the drawer in until it stops, then lift to allow the rollers to clear the
roller guide stop, and push in.
Changing
Oven
Light
Be sure the oven is unplugged and all parts are COOL before replacing the oven light bulb. Do not turn the oven light on
during a self-cleaning cycle. High temperature will reduce lamp life.
On some models an interior oven light will turn on automatically
when the oven is opened.
The oven light may be turned on when the door is closed by using the oven light switch located on the Electronic Oven
control.
The oven light bulb is covered with a glass shield held in place by a wire holder. THiS GLASS SHIELD MUST ALWAYS
BE IN PLACE WHEN THE OVEN IS IN USE.
To Replace the Light Bulb:
BE SURE OVEN iS COOL
t. Turn the power off at the main source.
2. Wear a leather-faced glove for protection against possible broken glass.
3. Replace bulb with a 40 Watt appliance bulb only.
4. Press wire holder to one side to release glass shield, change bulb and be sure to replace
glass shield.
24

Advertisement

Table of Contents
loading

Table of Contents