Kenmore 911.95361 Owner's Manual page 23

REMOVABLE PARTScontinued
CLEANING MATERIALS TO USE:
• Dishwashing detergent
• Warm water
• Scouring pad or soap-filled steel wool
pad
BROIL STOP POSITON
BUMP
RAISED BACK IN RACK
OF THE RACK
TO REMOVE:
1, Pull the racks out to the stop lock position.
2, Pull up the front of the rack and slide under
the bump of the rack guide.
TO CLEAN:
Clean with warm water and detergent. For
hard to remove stains, gently scrub with a
scouring pad or a soap-filled steel woo/pad.
Rinse well.
TO REPLACE:
1, Place the raised back of the rack onto the
rack guides.
2, Lift the front ef the rack until the raised back
slides under the bump of the rack guides.
3, Slide the rack all the way back.
TO REMOVE:
1. Open the door to the broil stop position.
2. Grasp the door at each side and rift up
and off the hinges. DO NOT LIFT
DOOR BY THE HANDLE.
CAUTION:
TO REPLACE:
1, Make sure the hinge arms are in the broil
stop position.
2, Lift the door by the sides.
3, Line up the slots at the bottom edge of the
door with the hinge arms.
4. Slide the door down onto the hinge arms as
far as it will go.
5, Close the door.
23