Burner Box Bottom; Control Knobs; Burner Grates; Burner Heads - Kenmore 911.32085 Owner's Manual

CARE AND CLEANING
CleaningAndRemovableParts
The cooktop can be raised or removed so
the area underneath (burner box bottom)
can be cleaned.
TO RAISE THE COOKTOP
1. Remove the burner grates, bowl and
control knobs
2, Grasp the cooktop at the front and
lift up.
8, Raise the support rod into place to
hold the cooktop while cleaning.
4. Secure the rod into the maintop
bracket on the cooktop.
Porcelain enamel can chip if dropped.
Handle porcelain enameled cooktops
carefully,
TO LOWER THE COOKTOP
t, Carefully remove the support rod from
the maintop bracket of the cooktop and
lower the cooktop.
2, Press the cooktop into place.
3, Make sure the strikes fit in the catches
to fasten the cooktop.
4, Replace the burner grates, bowls and
control knobs.
J
Maintop
CLEANING MATERIALS
• Detergent
• Hot water
TO CLEAN
A soap-filled steel wool pad may be
used, but will cause soma scratching and
dulling of the aluminum. Remove burners
for easy cleaning.
To clean stubborn soil on burner heads,
a Dip-It® solution is recommended. Put
enough water in a non-aluminum pan to
completely cover the burner head. After
the water boils, add 2 T. of Dip-It_
9rar_ulesper quart d water. Add slowly to
prevent foaming over. Then add burner
with head down and boil 20 minutes.
Remove burner and rinse in coot water.
Wipe any remaining soil off with a cloth or
soft brush. Be Not use commercial
oven cleaners, ammonia or other
alka|ine solutions on aluminum
because they will permanently
darken it.
10