Kenmore 911.32085 Owner's Manual page 11

CARE AND CLEANING
RemovableParts
Fig. A Gas Valve Orifice
Be careful not to disturb the air
shutter setting while cleaning. If
you need to readjust the air shutter, see
the Installation Instructions.
To Replace
1. Slip the air shutter over the gas valve
orifice (Fig. A),
2. Lower the burner assembly and hook
the tab in the slots in the burner
support (Fig. A)
3, Be sure both tabs are in theft slots, that
the burner sits level and straight and
that the flash tube forms a straight line
from the igniter to the burner (Fig. B).
Air Shutter
Fig. B
Ignite_
Burner
oft
_ Flash Tube
Burner Ports
The cooktop burners on your cooktop may
be removed for cleaning. Be sure all
cooktop knobs are tumed to OFF
and burners are cool, then remove
or raise the cooktop,
If shipping screws were not removed from
the burner when the cooktop was
installed, do so now (see your Installation
Instructions for information).
To remove
1, Grasp the burner head and tilt it to the
right to release the two tabs from the
burner support (A in fig. A).
2. Lift the end of the burner assembly,
then pull away from the front of the
range to free the air shutter from the
gas valve orifice (Fig. B).
3. Check all lighter and burner ports, If
they are clogged, use a wire or needle
to clear them.
11