Burner Cap; Burner H Ead - Kenmore 318201473 Installation Instructions Manual

Burner Cap
Cooktop S urfaceI
youcanquickly turn knobfromLITE to LOWEST
POSITION withoutextinguishing theflame,Flame
should beassmall a spossible w ithoutgoingout,
Note:Air mixture adjustment isnot required onsurface
burners.
Burner H ead Gas Opening
2_
Electrode
Figure 8
Turn on Electrical Power and Open Main Shutoff
Gas Valve
.
Check the Igniters
Operation of electric igniters should be checked after
the appliance and supply line connectors have been
carefully checked for leaks and the appliance has
been connected to electric power. To check for
proper lighting:
a. Push in and turn a surface burner knob to the
LITEposition. All electronic surface ignitors will
spark at the same time. However, only the
burner you are turning on will ignite.
b. The surface burner should light once the flow of
gas reached the surface burner. Each burner
should light within four (4) seconds in normal
operation after air has been purged from supply
lines. Visually check that burner has lit.
c. Once the burner lights, the control knob should
be rotated out of the LITE position.
There are separate ignition devices for each burner.
Try each knob separately until all burner valves have
been checked.
4. Adjust the "LOW" Setting of Regular Surface
Burner Valves (Figure 9):
a. Push in and turn control to LITE until burner ignites.
b. Quickly turn knob to LOWEST POSITION.
c. If burner goes out, reset control to OFF.
d. Remove the surface burner control knob.
e. Insert a thin-bladed screwdriver into the hollow valve
stem and engage the slotted screw inside. Flame size
can be increased or decreased by turning the screw.
Turn counterclockwise to increase flame size. Turn
clockwise to decrease flame size. Adjust flame until
Figure 9
5. Adjust the "LOW" Setting of the Dual (Bridge)
Surface Burner Valve (Figure 10):
Note: On the dual valve the low setting of each portion
(rear portion of bridge burner and the center portion of
bridge burner) should be adjusted individually.
a. Push in and turn control to LITE until the rear portion
of the bridge burner ignites only.
b. Quickly turn knob to LOWEST POSITION.
c. If burner goes out, reset control to OFF.
d. Remove the surface burner control knob.
e. The rear portion of the bridge burner flame size can
be increased or decreased by turning screw A (see
Figure 10). Use screw B to adjust the flame size of
the center portion of the bridge burner. Turn
counterclockwise the screw to increase flame size.
Turn clockwise the screw to decrease flame size.
Adjust flame until you can quickly turn knob from
LITEto LOWEST POSITION without extinguishing the
flame. Flame should be as small as possible without
going out.
Note: Air mixture adjustment is not required on surface
burners.
Figure 10