REMOVING LINT
1. Turn hand wheel toward you until needle is at its
highest position.
Remove bobbin and bobbin case.
2. Push levers (A) sideways.
3. Remove shuttle race cover (B). Then pull out shuttle
(C) by grasping axle.
4. Remove accumulated
lint and thread from all parts
of shuttle race.
5. Replace shuttle in race body, with axle facing out,
forming a perfect circle with driver (D).
6. Replace shuttle race cover (B), snap levers (A) into
position, then insert bobbin and bobbin case.
7. Do not attempt to force any of the above operation.
8. Occasionally remove the needle plate and clean feed
dog with a soft brush.
22