Table of Contents
Advertisement
Cleaning the Roat
Clean the float to prevent it from sticking. The float controls the water level in the
dishwasher;
sticking may cause an overflow or no water fill. When removing float
to clean, pull up firmly until it snaps out. To replace float, push down until float
locks into place. This will activate the float switch.
Important:
The small locking tabs are used to hold the float in place during
shipping.
If these tabs break off during removal, no harm is done. The float
will still function
properly.
Care of Drain Air Gap
If a drain air gap was installed for your built-in dishwasher,
check to make
sure it is clean, so the dishwasher
will drain properly.
Drain air gaps are
usually mounted
on the countertop
and can be inspected
by removing the
cover, The drain air gap is not part of your dishwasher
and is not
covered
by Sears warranty.
l! !
=l l,
Storage or Seasonal Use
tf dishwasher
is to remain idle for an extended
period of time in...
g Temperatures
,,
Shut off water and electrical
power.
Remove
access panel.
•
Disconnect
water lines from fill valve. Drain into a flat pan.
•
Disconnect
hoses from pump. Drain into a flat pan.
°
Reconnect
water lines to valve and hoses to pump.
=
Pour 1 quart of non-toxic,
RV (Recreational
Vehicle)-type
antifreeze
into
empty dishwasher.
Clean and
Remove
Particles
Collected
Here
Locking
Tabs
Drain Air Gap
Warm Temperatures
°
Pour 1 quart of non-toxic, RV-type antifreeze into empty dishwasher
to
_-
prevent pump seals from drying out and sticking.
Caution:
Before
using dishwasher
again, operate
empty machine
on Normal Wash cycle with detergent
in all cups.
,!!l
ii
.....
Hl l
Preparation for Moving
°
Disconnect electrical power,
•
Tape racks in place.
Turn off water supply.
Disconnect
water and drain lines.
•
Close door securely
and tape shut.
-
Wrap with blankets.
-
If using a hand truck, lift dishwasher from side in upright position only.
13
Advertisement
Table of Contents
