Kenmore 362.71330 Use & Care Manual page 40

PROBLEM POSSIBLE CAUSE
TOP BURNERS DO NOT •
LIGHT OR DO NOT
BURN EVENLY =
°
BURNER FLAMES VERY •
LARGE OR YELLOW
SURFACE BURNERS o
LIGHT BUT OVEN
DOES NOT
Make sure electrical plug is plugged into a live power outlet,
Burner holes on the side or around the top of burner may be clogged.
Remove burners (on models with standard twin burners) or burner heads
(on models with sealed burners) or burner caps on spill-proof models, and
clean them with a sewing needle or twist-tie. Make sure you do not enlarge
the holes. On spill-proof models, check electrode area for burnedoon food
or grease.
Make sure the drip pans (on some models) are installed correctly.
Pilot(s) is (are) not lit (on standing pilot models),. See the Lighting
Instructions for Standing Pilot Models section in Surface Cooking.
If range ts connected to LP gas, contact the person who installed your range
or made the conversion.
The oven gas shut-off valve may have accidentally been moved during
cleaning or moving.
To check the oven gas shut-off valve on standard twin burner models, raise tile
cooktop and look for the gas shut-off lever at the extreme right rear corner_
Follow the directions in box A or B that match your regulator type.
Standard Twin BurnerModels
Standard Twin Burner Models
Lever shown closed
PULL TO OPEN
To check the oven gas shut-off valve on sealed burner models, remove
the storage drawer, broiler drawer or kick panel and look for the gas shut-
off fever at the back of the range.
Sealed Burner Models
closed.PULL
4O