Kenmore 362.71330 Use & Care Manual page 36

STEP 5
Light the Pilots
(for models equipped with standing pilots)
The range should be installed in its permanent position
before any pilots are lit or adjusted,
Light the Surface Burner Pilots
CAUTION: Make sure the surface burner control knobs
are in the OFF position before attempting to light the pilots.
1o Raise the cooktop,
2. Light both pilots with a match
3o To avoid pilot outage, use caution when closing
cooktop after lighting pilots_
NOTE: Do not leave standing pilot lit in a newly
constructed or remodeled home or apartment that
wilt be unoccupied for' more than a month.
Each pilot flame was adjusted at the factory to be
approximately s/16"(8 mrn) tall A tinge of yellow appearing
at the upper tip is normal. If you find pilot adjustment is
necessary, follow instructions at right.
Adjust the Surface Burner
Pilots if Necessary
1. Raise the cooktop_
2o Locate the pilot adjustment screw, tt can be accessed
through the small hole near the center of the manifold
panel,
3. To adjust, use a blade-
type screwdriver with a
shaft diameter of less
than 3/_6"(5 ram). Turn
pi_otadjustment screw
until pilot is sag"(8 ram)
high. Do not reduce
the flame to less than
_A6"(8 mm) or pilot outage may occur. A pilot flame
burning higher than recommended may generate soot
(carbon black) on the bottom of your cooktop.
Light the Oven Pilot
CAUTION: Make sure the OVEN TEMP knob is tn the
OFF position before attempting to light the pilot,
1. Remove the broiler drawer by sliding the drawer ail the
way out and then lifting slightly to remove it from its
tracks
2_
3o
Locate the pilot at the back of the broiler compartment,
The pilot is attached to the left side of the oven burner.
Light the pilot with a
match No adjustments are
required for natural gas,
If range is connected to
LP gas, contact the person
who installed your range
or made the conversion_
36