Oven Cleaning - Frigidaire PGLEF385EC8 Guide Manual

Oven Cleaning
Self-Clean Cycle Time Length
The SPEED CLEAN : Speed, CLEAN 'Nett0yer ano IVI_AA _,L'-AN Ua×x ' pads control the Serf-Cleaning feature. If you are
dean clean
planning to use the oven directly after a serf-clean cycle remember to allow time for the oven to coo[ down and the oven
door to unlock. This normally takes about one hour. So a 3 hour serf-dean cycle will actually take about 4 hours to
N_t0y, g0 cieaiicycle (3 hour) for average soils, and a
complete. *it is recommend to use a Speed cycle (2 hour) for light soils, a Nett0yer
dean
"qettoyage
ua×xcycle (4 hour) for heavy soils (to assure satisfactory results).
clean
NOTE: A smoke eliminator in the oven vent converts most of the soil into a colorless vapor.
During the Self-Cleaning cycle, the outside of the range can become very hot to touch. DO NOT leave small
children unattended near the appliance.
To avoid possible burns use care when opening the oven door after the Self-Cleaning cycle. Stand to the
side of the oven when opening the door to allow hot air or steam to escape.
DO NOT force the oven door open. This can damage the automatic door locking system. Use caution and avoid
possible burns when opening the door after the Self-Cleaning cycle has completed. The oven may still be VERY HOT.
INSTRUCTIONS PRESS DISPLAY
To start an immediate Self-Cleaning cycle or to set a delay start time of 4:30 and shut of
automatically (example provided is a default 3 hour Self-Clean cycle):
,
2.
Nett0yer
Be sure the clock is set with the correct time of day, the oven is empty
and the oven door is closed.
Press clean "CLEAN" will flash and "3:00" HR will show in the display
Nett0yer"
(Fig. 1). The control will automatically clean for a 3 hour period (default self-
cleaning cycle time). Note: If a 2 or 4 hour clean time is desired, press
N_°Y"_° ua×xfor a 4 hour clean time. Set the cleaning
Speed
:for 2 hour or press
Nettoyage
dean dean
time based on the amount of soil: light, medium or heavy (* See above).
,
.The "DOOR LOCKED" icon will flash; "CLEAN" icon and
the letters "CLn" will remain on in the display (Fig. 2).
4. As soon as the control is set, the motor driven oven door lock will begin
to close automatically. Once the door has been locked the "DOOR
LOCKED" indicator light will stop flashing and remain on. Also, the oven
icon will appear in the display (Fig. 3).
Note: Allow about 15 seconds for the oven door lock to close.
Neit0yage Nettoyage
Speed or Maxx
dean dean
Fig. 1
Fig. 2
Fig. 3
NOTE: If the optional delay Self-Clean feature is needed, finish steps 5-7. If Serf-Clean is started immediately
skip the remaining steps and continue with "When the Self-Clean cycle is done" on the following page.
Start tilne
5. Press H .....d_.Enter the desired start time using the number pads 4
d_patt
0 (Fig. 4).
.... ..... CLn"
6. Press _PA_ . The icon will turn off; "DELAY", "DOOR LOCKED"
and "CLEAN" icons will remain on (Fig. 5).
7. The control will start the self-cleaning at the set start time, for the period of
time previously selected. At that time, the icon "DELAY" will go out;
"CLn" and oven icon will appear in the display (Fig. 6).
Start tilhe
Heure de
d6patt
4 0
Fig. 4
Fig. 5
Fig. 6
16