Setting The Clock - Frigidaire PLCS389ECE Control Manual

Setting the Clock

Clock
The pad is used to set the clock. The clock may be set for 12 or 24 hour time of day
Horloge
operation. The clock has been preset at the factory for the 12 hour operation. When the
range is first plugged in, or when the power supply to the range has been interrupted, the
timer in the display will flash along with "PF" (power failure, See Figure 1).
When PF appears in the display and 12:00 is flashing, press
but after 10 seconds a beep will sound and PF will disappear.
INSTRUCTIONS
To set the clock (example below for 1:30)
Clock
1. Press . "CLO" will appear in the display (Figure 2).
Horloge
2. Press
1 3 0
3). "CLO" will stay in the display. Press
disappear and the clock will start (Figure 4).
Changing between 12 or 24 hour time of day display
1. Press and hold Clock
Horloge
"12Hr" (Figure 5) or "24Hr" (Figure 6) will appear in the display
and the control will beep once.
Clean
2. Press to switch between the 12 and 24 hour time of day
Nettoyer
display. The display will show either "12Hr" (Figure 5) or "24Hr"
(Figure 6).
START
3. Press to accept the change or press
DÉPART
change.
4. Reset the correct time as described in To set the Clock above.
Please note that if the 24 hour time of day mode was chosen,
the clock will now display time from 0:00 through 23:59 hours.
pads to set the time of day to 1:30 (Figure
START
DÉPART
for 7 seconds (Figure 3). After 7 seconds,
Clear/Off
Annuler
Clear/Off No sound will be heard,
.
Annuler
. "CLO" will
Clock
Horloge
to reject the
2
PRESS
Clock
Horloge
1 3 0
START
DÉPART
for 7 seconds
Clean
Nettoyer
START
or
Clear/Off
DÉPART
Annuler
Figure 1
DISPLAY
Figure 2
Figure 3
Figure 4
Figure 5
Figure 6