Frigidaire FPEF3081MFA Use & Care Manual page 43

Problem Possible Causes
Oven portion of Incorrect oven control setting.
appliance does not
operate.
Entire appliance does
not operate.
Solutions
Be sure the oven control was set correctly for the requested
feature. See Setting Oven Controls section and review
instructions for the desired cooking function in this manual or see
"Entire appliance does not operate" in this checklist.
Lock feature may be active. Cancel the lock feature (some models).
Power supply to appliance Be sure appliance power cord is plugged properly to electrical
disconnected or electrical outlet. Check house circuit breaker; reset if needed. If the electric
power outage, service to the house is out, call your local electric utility for
service.
Service wiring is incomplete. Contact your dealer, installing agent or authorized service agent
for assistance.
Range is not level. Floor is not level, weak or If floor under range is sagging or sloping, contact a carpenter to
unstable, correct the problem.
The cooktop or oven racks are To correct, place oven rack in center of oven. Place a bubble (or
not level, spirit) level centered on the oven rack. Adjust by turning leveling
legs at bottom of range until the oven rack rests level.
Cabinet alignment may make Be sure kitchen cabinets are square & have sufficient room for
range appear not level, appliance clearance.
Cannot move Carpet interferes with range. Provide sufficient space so appliance may be lifted over carpet.
appliance easily. .............................................................................................................................................................................................
Appliance must be Cabinets are built in too tightly Contact builder or installer to make appliance accessible.
accessible for to appliance sides.
service.
Convect fan makes The convect fan may turn ON This is normal. On some cooking features the convect fan may run
noise (some models), or OFF automatically, until the feature is done or the door was opened or closed.
Convect fan turns ON Oven door is open. The convect fan will turn OFF if the oven door is opened while any
and OFF while cooking convect feature is active. Close oven door.
(some models).
Convect fan turns on For some models the convect This is normal (some models).
with features that fan may turn ON while
should run without a preheating.
fan (some models).
Oven control displays
"Prob ERR". The
probe is not
recognized by the
oven control (some
models).
The probe is not fully inserted Double check that the temp probe is fully inserted into probe
into the probe receptacle, receptacle. Use only the probe originally supplied with range.
If the error code persists, the Remove the probe from receptacle and oven. The oven may still
probe may be damaged or the be used normally without the probe. Call your authorized service
probe cable has a short, agent for a replacement probe.