Frigidaire FPEF3081MFA Use & Care Manual page 32

Setting the Sabbath feature (cont'd)
To turn off the oven but keep the Sabbath feature
active:
Presscancel, cancel
To turn off the Sabbath feature"
Press and hold both the
bake time and delay start pads
for at least 3 seconds. The control
will beep and SAb will disappear
from the display. The oven is no
longer programmed for the
Sabbath feature.
bake
time
+ delay
start
What to do during a power failure or power
interruption after the Sabbath feature was
activated:
Should you experience a power failure or interruption, the
oven will shut-off. When power is restored the oven will not
turn back on automatically. The oven will remember that it
is set for the Sabbath and the oven display will show the
message "SF" for Sabbath failure (Fig. 1).
Fig. 1
• If a delay start time longer than 12 hours (maximum of
24 hours) is desired, set the display mode for the 24
hour setting. For detailed instructions see the section
"Setting 12 or 24 hour display modes".
• It is not advised to attempt to activate any other
program feature except bake while the Sabbath
feature is active. ONLY the following keypads will
function correctly with the Sabbath feature: 0-9
number keypads, bake, start & cancel. All other
keypads should not be used once the Sabbath feature
isactive.
• You may change the oven temperature once baking
has started. Press bake, enter the oven temperature
change (170 to 550F °) and press start (for Jewish
Holidays only). Remember that the oven control will no
longer beep or display any further changes once
the oven is set for the Sabbath feature.
• If the keep warm feature was activated and the
Sabbath feature was set the keep warm feature will
automatically shut-off the oven after 3 hours.
The food may be safely removed from the oven while still in
the Sabbath feature, however the oven cannot be turned
back on until after the Sabbath/Holidays.
After the Sabbath observance turn OFF the Sabbath
feature. At the same time press and hold both the
bake + delay keypads for at least 3 seconds.
time start
SF will disappear from the display and the oven may be
used with all normal functions.