JVC AV-27050 User Manual page 11

GETTING STARTED
POWER
[] Make sure that the TV/CATV switch is set to T_ Switch to CAW only to operate a cable box,
[] Press the POWER button on the remote control or the TV front panel, The On Timer lamp will glow red,
[] The first time you turn on the TV, the "Plug In Menu" will appear, You should turn to the Plug In
Menu section (page 15) now to learn more about this menu,
[] To turn the power off, press the POWER button again, The On Timer lamp will go out,
[] When the TV is off, the On-Timer lamp remains on while the On/Off Timer function is active, but at
a reduced brightness,
ADJUSTING VOLUME
D Use the VOLUME -/÷ buttons ( • • ) on the front panel or remote control, Use the VOLUME
- ( • )
button to lower the volume, Press the VOLUME ÷ button ( • ) raise the volume,
D
iiiiiiiiiiiiii LLL:: iLL i: ¸
Press the MUTING button to instantly turn the volume off to zero, To restore the volume to the
previous volume level, simply press the MUTING button again,
CHANGING CHANNELS
_1_ 10 key direct access.
Press the numbers on the remote's 10 key pad, For single-digit channel numbers press 0 then the
number, For channels above 100, press the 100+ button plus the 2-digit number,
D CHANNEL --/+ button (4,V).
Press the CHANNEL -/+ button, it will scan the channels in order,
[] NOTE; After y,ou operate the Auto Tuner Setup (page 15), all of the blank, or empty, channels will be
removed from scanning so that there is no noise or channel snow when y,ou scan, only, active channels,
Return.
Press and release the RETURN+ button to return to the previous channel, First, select a channel
(game #1), Then, select another channel (game #2) with the 10 key pad and push the RETURN+
button to flip directly back and forth,
Return+.
Press and hold down the RETURN+ button for three seconds, The message, "RETURN CHANNEL
PROGRAMMED !" will appear and you can scan as you wish, Press RETURN+ again and you will go
back to the Return+ channel,
To cancel a Return+ channel, press and hold down the RETURN+ button for another three seconds
and the message, "RETURN CHANNEL CANCELLED !" appears,
[] Pressing a number key, or turning the set off will a/so cancel a Return+ channel,