Rear Panel Diagrams; Cable & Vcr Connections - JVC AV-27050 User Manual

CONNECTIONS
REAR PANEL DIAGRAMS
_._ i__ AUDIO VIDEO S:_JIDEO
L_ NO INPUT
INPUT
i®® -o
R L OLrr
REAR PANEL DIAGRAM
AV-36050 • AV-32050 • AV-27050
AV-36020 • AV-32020
(The rear panels for the above modes are nearly
identical, The only clifference between them is a small
difference in the size of RF panels,)
REAR PANEL DIAGRAM
AV-32015
CABLE & VCR CONNECTIONS
There are three basic types d antenna or cable hookups, For VCR hookup only, see the Quick Setup Guide,
1} If:you nave an antenna, or a cable TV system that does not require you to use a cable box to tune the
cnannels use Diagram #1.
2} If you nave a cable system that requires you to use a cable box to access allchannels use Diagram #2.
3) If you nave a cable system that requ res you to use a cable pox to access certain bremlum
cnannels but not regular Daslc cnannels, use Diagram # 3.
For information on working Picture in Picture (PIP), please see the PIP section on page 28
1) Connect cable or antenna RF wire outfrom the wall, into the splitter RF input,
2) Connect RF wire Out from the splitter RF output, in to the VCR RF input,
3) Connect RF wire Outfrom the splitter RF output, into the TV VHF/UHF input,
4) Connect yellow video cable out from the VCR Video output, in to the TV Video input jack,
5) Connect white audio cable out from the VCR Left Audio output, in to the TV Left Audio input jack,
6) Connect red audio cable out from the VCR Right Audio output, in to the TV Right Audio input jack,
[] If your VCR is mono it has only one audio outjack, connect it to TV L/Mono input,