Basic Operations; Turning The Power On And Off; Adjusting The Volume - JVC RV-NB10W Instructions Manual

Basic operations
SOUND--
ACS--
_r_ @/I ON/STANDBY
ooo9 H
ooo08_ DISPLAY ooo11
/I
oo%, SUPER WOOFER
-
SUPERWOOFER_ 7 I c _,,,_ ) _
VOLUME+/- ___--VOLUME +/-
SOUND \ " _ _
STANDBY
d,.[) / I ON/STANDBY- indicator
ACTIVE CLEAR- ACS ON/LEVEL
SOUND indicator
Note: The lighting condition i:or the STANDBY indicator and the
display differs depending on tile power source.
Power source STANDBY indicator/display
= Tile STANDBY
indicator lights when
power is turned off.
AC power . Backlighting of the display is illuminated
when power is turned on.
. The STANDBY indicator does not light.
Batteries or car . Backlighting of the display is not
illuminated.
battery (DCI2V) ': . With the system turned off (at standby), no
indication is shown on the display.
* If no source is playing and no operation is done for about 4
minutes, "DC OFF" starts flashing on the display for about one
minute be[ore the system turns off automatically (except when
the source is W1RELESS/FM/AM or AUX, or when the
microphone (or guitar) is used).
_rning off the system
Press (L)/I ON/STANDBY again,
The STANDBY indicator lights up when the system is operated on
AC power.
. When the AC power is used, the CLOCK indicator and the time
are displayed without backlighting.
1 oN/
O/Is*ANDBY
ON/STANDBY t
STANBSy
-- © ---
or
1/ l
On system On remote control
_ Some power is always consumed even though power is turned
off (called standby mode).
@ To disconnect the system from mains (AC) supply completely,
unplug the AC power cord from the AC outlet. When you
unplug the AC power cord, the clock will be reset to "AM 12:00"
if no memory backup batteries are installed.
_rning on the system
Press _/I ON/STANDBY,
• When the system is operated on batteries or car battery (DC 12V),
press In, L)/ON/STANDBY on the system.
The STANDBY indicator goes out when the system is operated on
AC power.
The display comes on and the system is ready to continue in the
mode it was in when the power was last turned off.
1 ON/
0/I STANDBY ON/STANDBY
(_ ©/I
or
On system On remote control
STANDBY
Q
You can adjust the volume level between 0 and 50.
Using the system
Turn the VOLUME +/- control clockwise to
increase the volume or turn it
counterclockwise to decrease the volume,
_i_ _"_ I I,',1 I I1','11 . .......
'...' U L..U i'ii:, i'
Using the remote control
Press VOLUME + to increase the volume or
press VOLUME - to decrease it,
When y(m press and hold V()LUME + or , the volume changes
rapidly.
CAUTION: DO NOT start playing any source
without first setting the volume to minimum, as a
sudden blast of sound can damage your hearing,
speakers and/or headphones.
For private listening
Connect a pair of headphones to the PHONES
jack on the rear of
the system (see page 6). No sound comes out of the speakers.
Be sure to turn down the volume bet\we connecting or putting on
headphones.
7