Before You Start Recording; Standard Recording - JVC RV-NB10W Instructions Manual

I Recording
OD li_/ll m_ _TAPE <
AOX W,RE ESS
REVERSE
OOE 4/
AUX
BEAT CUT
CD _/ll TAPE -_
ONE TOUCH REC g
Things to know before you start
recording
V It should be noted that it may be unlawful to re-record
pre-recorded tapes, records, or discs without the
consent of the owner of copyright in the sound or
video recording, broadcast or cable programme and
in any literary, dramatic, musical, or artistic work
embodied therein:
V When you want to record onto both sides of a tape, you can set
reverse mode to __). Recording automatically stops alter
recording in the reverse (-,_) direction. Therefore, make sure that
the tape direction is t\wward (_,-) when recording with reverse
mode is on.
V The recording level is automatically set correctly, so it is not
affected by the VOLUME control on the system or by adjusting
the sound effects. Thus, during recording you call adjust the
sound you are actually listening to without affecting the
recording level.
V Two small tabs on the back of the cassette tape, one for side A
and one for side B, can be removed to prevent accidental erasure
or recording.
V To record on a cassette with the tabs removed, you must cover
the holes with adhesive tape first. However, when a type 11[tape
is used, only cover part of the hole as shown, since the other part
of the hole (type II detection slot) is used to detect the tape type.
Type II detection
slot
You can record ally sound source to tape.
The sources are disc, tuner, auxiliary equipment, microphone, and
guitaa The microphone sound and guitar sound can be mixed with
ally source.
_: |flsert a blank or erasable cassette tape
into the cassette deck.
Be sure that the tape direction indicator and the tape insertion
direction are as follows:
[Forward and reverse recording]
Tape direction indicator
(Forward)
'_'Recording will be made on
the tape side facing you.
<l
(Reverse)
'_'Recording will be made on
the opposite side of the tape.
Tape insertion direction
...................................................... t
(Front view)
(Front view)
Adhesive tape
V Type I and type H tapes can be used t\w recording.
Note:
At the start and end of cassette tapes, there is leader tape which
cannot be recorded onto. Thus, before recording, wind on the
leader tape first to ensure getting the beginning of the recording.
CAUTION: If a recording you make has excessive
noise or static, the system may have been too
close to a TV which was on during the recording.
Either turn off the TV or increase the distance
between the TV and the system.
• If the tape direction <! (reverse) is lit, press TAPE 41 _* to change
the direction. (In this case, since the tape play starts, you need to
press I. Then, press I-_1-,_ to rewind the tape up to the end point of
the leader tape which cannot be recorded onto.)
, If the inserted tape is not fully rewound, press 14-,4 to rewind the
tape up to the end point of the leader tape which cannot be
recorded onto.
you wantto ,ece,donbethsidesofthe
tape, press REVERSE MODE on the re_ete
control to set the cassette deck in reverse
mode.
Press the breton mltil "_) " is lit.
r',epa,e thesouse, e.ample, t uningin
to a radio station, or turning on the
connected auxiliary equipment.
Rote: F'or disc recording, refer to "Disc direct recording"
described on page 15.
Continued on the next page...
14